Deployment Guide

27 Dell EMC Networking OS10EE FCoE Deployment with FSB
7 S5248-ON FSB validation
After configuring connected devices, many commands are available to validate the network configuration.
This section provides a list of the most common commands and their output for this topology.
Note: The following commands and outputs that are shown are for the S5248F-Leaf1. The output for the
S5248U-Leaf2 is similar. For additional commands and outputs related to the leaf-spine portion of the
topology, such as VLT, and BGP, see
Dell EMC Networking Layer 3 Leaf-Spine Deployment and Best
Practices with OS10EE.
7.1 show interface status
The show interface status | grep up command is used to verify required interfaces are up, and
links are established at their appropriate speeds.
S5248-Leaf1# show interface status | grep up
Port Description Status Speed Duplex Mode Vlan Tagged-Vlans
Eth 1/1/31 Server 1 up 10G full T 1 1001,1612-1616
Eth 1/1/32 Server 2 up 10G full T 1 1001,1612-1616
Eth 1/1/33 Server 3 up 10G full T 1 1001,1612-1616
Eth 1/1/34 Server 4 up 10G full T 1 1001,1612-1616
Eth 1/1/41:1 S4148U-F_Port.. up 10G full T 1 1001
Eth 1/1/53 Z9264F-Spine1.. up 100G full -
Eth 1/1/54 Z9264F-Spine2.. up 100G full -
Eth 1/1/55 VLTi up 100G full -
Eth 1/1/56 VLTi up 100G full -
7.2 show vlan
The show vlan command is used to verify configured VLANs and the interfaces they are applied to.
S5248-Leaf1# show vlan
Codes: * - Default VLAN, M - Management VLAN, R - Remote Port Mirroring VLANs,
@ – Attached to Virtual Network
Q: A - Access (Untagged), T - Tagged
NUM Status Description Q Ports
* 1 Active A Eth1/1/1-
1/1/40,1/1/41:1,1/1/42:1,1/1/43:1,1/1/44:1,1/1/45-1/1/52
A Po1000
1001 Active T Eth1/1/31-1/1/34,1/1/41:1
1612 Active vMotion T Eth1/1/31-1/1/34
T Po1000
1613 Active vSAN T Eth1/1/31-1/1/34
T Po1000
1614 Active web T Eth1/1/31-1/1/34
T Po1000
1615 Active app T Eth1/1/31-1/1/34
T Po1000
1616 Active db T Eth1/1/31-1/1/34
T Po1000
4094 Active T Po1000