Owners Manual

FRU Device Description : FRU_PSU2 (ID 2)
Board Mfg Date : Fri Jan 12 18:47:00 2018
Board Mfg : DELL
Board Product : PWR SPLY,495W,RDNT,DELTA
Board Serial : CNDED0081G01GL
Board Part Number : 0GRTNKA02
FRU Device Description : FRU_FAN1 (ID 3)
Unknown FRU header version 0x00
FRU Device Description : FRU_FAN2 (ID 4)
Board Mfg Date : Mon Feb 12 08:01:00 2018
Board Mfg : Dell
Board Product : <platform>
Board Serial : CNCES008260036
Board Part Number : 07CRC9X01
Product Manufacturer : Dell
Product Name : <
platform>
Product Version :
Product Serial :
Product Asset Tag : D4SSG02
For more information, see the IPMI Specication v2.0 chapter 22.26 Set User Access Command, 22.28 Set User Name Command, and
22.30 Set User Password Command.
• Request data byte 1—[7]
– 0b-Do not change the following bits in this byte
– 1b-Enable changing bits in this byte
• Request data byte 1—[6] User restricted to callback
– 0b-User Privilege Limit is determined by the User Privilege Limit parameter for both callback and non-callback connections.
– 1b-User Privilege Limit is determined by the User Privilege Limit parameter for callback connections, but is restricted to Callback
level for non-callback connections. A user can only initiate a callback when he/she 'calls in' to the BMC, but after the callback
connect is made, the user could potentially establish a session as an Operator.
• Request data byte 1—[5] User link authentication enable/disable. This is used to enable/disable a user's name and password
information for link authentication. Link authentication itself is a global setting for the channel and is enabled/disabled via the serial or
moden conguration parameters.
– 0b-disable user for link authentication
– 1b-enable user for link authentication
• Request data byte 1—User IPMI Messaging enable/disable. This is used to enable/disable a user's name and password information for
IPMI messaging. In this case, IPMI Messaging means the ability to execute generic IPMI commands that are not associated with a
particular payload type. For example, if you disable IPMI Messaging for a user, but that user is enabled for activating the SOL payload
type, IPMI commands associated with SOL and session management, such as Get SOL Conguration parameters and Close Session
are available, but generic IPMI commadns such as Get SEL Time are not.
– 0b-disable user for link authentication
– 1b-enable user for link authentication
• Request data byte 2—User ID
– [7:6] reserved
– [5:0] User ID. 00000b = reserved
• Request data byte 3—User limits
– [7:6] reserved
– [3:0] User Privilege Limit. This determines the maximum privilege level that the user can to switch to on the specied channel.
◦ 0h-reserved
◦ 1h-Callback
◦ 2h-User
◦ 3h-Operator
◦ 4h-Adminstrator
18
Conguration methods