Administrator Guide

Example
DellEMC(conf-if-te-1/1/1)# storm-control pfc in queue-drop-state clear
disable storm-control pfc
You can disable the PFC storm globally.
Syntax
disable
Parameters None
Defaults None
Command Modes CONFIGURATION (conf-storm-control-pfc)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6000, S6000–ON, S61000–ON, Z9100–ON.
Usage Information The disable command is used to disable the PFC storm feature globally. By default, PFC storm feature is
enabled on all the interfaces on which "storm-control pfc in queue-drop" configuration has been applied.
Example Use the storm-control pfc command in the configuration mode to enter the 'storm-control-pfc'
configuration mode. The commands provisioned in this mode are applicable for all the interfaces that have PFC
storm enabled.
DellEMC(conf)#storm-control pfc
DellEMC(conf-storm-control-pfc)#disable
show storm-control pfc status
You can view the status of the PFC storm on a stack unit with specific port set.
Syntax
show storm-control pfc status stack-unit {unit-number} port-set {portpipe-
number}
Parameters
unit-number Enter the stack unit number.
portpipe-number Enter the port set number.
Defaults None
Command Modes EXEC Privilege.
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6000, S6000–ON, S6100–ON, Z9100–ON.
Usage Information The show storm-control pfc status command is used to view the status of the PFC storm on the
specified stack unit and the port set.
Example
1476 Storm Control