Administrator Guide

Version Description
8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added support for the non-contiguous mask and added the monitor option.
6.5.10 Expanded to include the optional QoS order priority for the ACL entry.
Usage Information
The order option is relevant in the context of the Policy QoS feature only. For more information, see the “Quality
of Service” section of the Dell EMC Networking OS Configuration Guide.
The software cannot count both packets and bytes; when you enter the count byte options, only bytes are
incremented.
Related
Commands
• ip access-list extended — create an extended ACL.
•
• permit tcp — assign a permit filter for TCP packets.
• permit udp — assign a permit filter for UDP packets.
permit icmp
Configure a filter to allow all or specific ICMP messages.
Syntax
permit icmp {source mask | any | host ip-address} {destination mask | any |
host ip-address} [type] [dscp] [message-type] [count [byte] | log] [order]
[monitor] [fragments] [no-drop]
To remove this filter, you have two choices:
• Use the no seq sequence-number command if you know the filter’s sequence number.
• Use the no permit icmp {source mask | any | host ip-address} {destination mask
| any | host ip-address} command.
Parameters
source Enter the IP address of the network or host from which the packets were sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified in
A.B.C.D format, may be either contiguous or noncontiguous.
any Enter the keyword any to match and drop specific Ethernet traffic on the interface.
host ip-address Enter the keyword host and then enter the IP address to specify a host IP address.
destination Enter the IP address of the network or host to which the packets are sent.
type Enter the ICMP packet type. The following types are available:
For IPv4:
echo count
echo-reply count
host-unreachable count
host-unknown count
network-unknown count
net-unreachable count
packet-too-big count
parameter-problem count
port-unreachable count
source-quench count
time-exceeded count
Access Control Lists (ACL) 201