Administrator Guide

Usage Information
Use the show default-gateway command to view the current default gateway.
Related
Commands
show_default-gateway— Change the primary, secondary, or default boot image configuration.
etheraddr <macaddr>
Assign the management port MAC address.
Syntax etheraddr <macaddr>
Parameters
mac-address
Enter a MAC address in standard format.
Command Modes BOOT_ADMIN
Command History
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.0.2.0 Introduced on the S6000.
Usage Information
Use this command to assign a MAC address if FTOS cannot find a default MAC address.
Example
BOOT_ADMIN # etheraddr aa:aa:aa:aa:aa:aa
<Macaddr> XX:xx:xx:xx:xx:xx
No defaults for this
ignore enable-password
Reload the system software without the enable password configured.
Syntax
ignore enable-password
Command Modes BOOT_USER
Command History
Version Description
9.10(0.0) Introduced on the S6100.
9.8(1.0) Introduced on the Z9100–ON.
9.0.2.0 Introduced on the S6000.
Usage Information
When you enter the reload command and the system reboots, you will not be prompted for a password to enter
the EXEC Privilege mode (normally you are required to enter the enable command).
If your console or Telnet session expires after you used the ignore enable-password command, you are
prompted for an
enable password when you re-establish the session
Related
Commands
reload — Exit from this mode and reload FTOS.
Boot Command Line Interface 321