Administrator Guide

bgp default local-preference
Change the default local preference value for routes exchanged between internal BGP peers.
Syntax
bgp default local-preference value
To return to the default value, use the no bgp default local-preference command.
Parameters
value Enter a number to assign to routes as the degree of preference for those routes. When
routes are compared, the higher the degree of preference or local preference value, the
more the route is preferred. The range is from 0 to 4294967295. The default is 100.
Defaults 100
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
All routers apply the bgp default local-preference command setting within the AS. To set the local
preference for a specific route, use the set local-preference command in ROUTE-MAP mode.
Related
Commands
• set local-preference — assign a local preference value for a specific route.
bgp dmzlink-bw
Enables BGP Link Bandwidth.
Syntax
bgp dmzlink-bw
To disable BGP Link Bandwidth, enter the no bgp dmzlink-bw command.
Parameters
dmzlink-bw Enter the keyword dmzlink-bw to enable BGP Link Bandwidth in BGP multipath.
Defaults N/A
Command Modes ROUTER BGP
340 Border Gateway Protocol