Administrator Guide

channel disables all traffic on the port channel and the individual interfaces within the port channel. To enable a
port channel, enter no shutdown on the port channel interface and at least one interface within that port
channel.
The shutdown and description commands are the only commands that you can configure on an interface
that is a member of a port channel.
Related
Commands
• interface port-channel — create a port channel interface.
• interface vlan — create a VLAN.
• show ip interface — display the interface routing status. Add the keyword brief to display a table of
interfaces and their status.
speed (for 10/100/1000/10000 interfaces)
Set the speed for 10/100/1000/10000 interfaces. Set both sides of a link to the same speed (10/100/1000/10000) or to auto or the link
may not come up.
Syntax
speed {10 | 100 | 1000 | 10000 | auto}
To return to the default setting, use the no speed {10 | 100 | 1000 | 10000} command.
Parameters
10 Enter the keyword 10 to set the interface’s speed to 10 Mb/s.
NOTE: This interface speed is not supported on the LC-EH-GE-50P or the
LC-EJ-GE-50P card. If the command is entered for these interfaces, an
error message appears.
100 Enter the keyword 100 to set the interface’s speed to 10/100 Mb/s.
NOTE: When this setting is enabled, only 100Base-FX optics are supported
on the LC-EH-GE-50P or the LC-EJ-GE-50P card.
1000 Enter the keyword 1000 to set the interface’s speed to 1000 Mb/s. Auto-negotiation is
enabled. For more information, refer to negotiation auto.
NOTE: When this setting is enabled, only 1000Base-FX optics are supported
on the LC-EH-GE-50P or the LC-EJ-GE-50P card.
10000 Enter the keyword 10000 to set the interface’s speed to 10000 Mb/s. Auto-negotiation
is enabled. For more information, refer to negotiation auto.
auto Enter the keyword auto to set the interface to auto-negotiate its speed. Auto-
negotiation is enabled. For more information, refer to negotiation auto.
Defaults auto
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.14.1.2 Introduced the option 10000 speed setting on the S5048F-ON.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Added support for fanned–out 1 Gigabit SFP port.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
686 Interfaces