Administrator Guide

Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.11.1 Introduced on the S55, S60, and S4810
8.1.1.0 Introduced on the E-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Usage Information This command is found on the Management interface only.
Related
Commands
• interface ManagementEthernet — configure the Management port on the system (either the Primary or
Standby RPM).
• management route — configure a static route that points to the Management interface or a forwarding
router.
stack-unit portmode
Split a single 40G port into four 10G ports.
Syntax
stack-unit stack-unit port number portmode quad
Parameters
stack-unit Enter the stack member unit identifier of the stack member to reset.
number Enter the port number of the port to be split. The total number of ports are 32. The range
is from 1 to 32.
port Enter the keyword port then the port number to specify the port where fanout mode is
specified.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.7(0.0) Added support for dynamically fanning-out of interfaces on S6000. Introduced on the
S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
688 Interfaces