Concept Guide

Server IP address : 10.16.127.35
BOOT_USER #
4 Assign an IP address and netmask to the Management Ethernet interface.
BOOT_USER # interface management ethernet ip address ip_address_with_mask
For example, 10.16.150.106/16.
5 Assign an IP address as the default gateway for the system.
default-gateway gateway_ip_address
For example, 10.16.150.254.
6 The environment variables are auto saved.
7 Reload the system.
BOOT_USER # reload
Viewing the Reason for Last System Reboot
You can view the reason for the last system reboot. To view the reason for the last system reboot, follow this procedure:
• Use the following command to view the reason for the last system reboot:
EXEC or EXEC Privilege mode
show reset-reason [stack-unit {unit-number | all}]
Enter the stack-unit keyword and the stack unit number to view the reason for the last system reboot for that stack unit.
Enter the stack-unit keyword and the keyword all to view the reason for the last system reboot of all stack units in the stack.
DellEMC#show reset-reason
Cause : Reset by User through CLI command
Reset Time: 11/05/2017-08:36
DellEMC# show reset-reason stack-unit 1
Cause : Reset by User through CLI command
Reset Time: 11/05/2017-08:36
Disabling Syslog Messages for SNMP Authentication
Failure Events
The system generates syslog messages for SNMP authentication events. Over time, these messages can ll up the syslog le on the
system, making analyzing system logs a cumbersome task. You can disable syslog messages for SNMP authentication failure events on the
system. To disable these messages, follow this procedure:
• Disable syslog messages for SNMP authentication failure events.
CONFIGURATION mode
logging disable-syslog snmp auth-failure
NOTE
: This command does not disable SNMP traps for SNMP authentication failure events.
Management 83