Service Manual

vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to display
OSPF neighbors corresponding to that VRF.
NOTE: If you do not specify this option, neighbors corresponding to the
default VRF are displayed.
interface
(OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
•
For a port channel interface, enter the keywords port-channel then a
number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults none
Command Modes
EXEC
EXEC Privilege
Command History
Version Description
9.7(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Introduced support for OSPFv3 on the S4810 and Z9000.
8.3.19.0 Introduced on the S4820T.
7.8.1.0 Added support for the C-Series.
7.4.1.0 Introduced on the E-Series.
Example
Dell#show ipv6 ospf 3 neighbor gi 1/2
Neighbor ID Pri State Dead Time Interface ID Interface
63.114.8.36 1 FULL/DR 00:00:38 4 Te 1/2/1
Dell#
timers spf
Set the time interval between when the switch receives a topology change and starts a shortest path rst (SPF) calculation.
S6000–ON
Syntax
timers spf delay holdtime
To return to the default, use the no timers spf command.
Parameters
delay Enter a number as the delay. The range is from 0 to 4294967295. The default is 5
seconds.
1008
Open Shortest Path First (OSPFv2 and OSPFv3)