Service Manual

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S6000 ON

1021

• For a Port Channel interface, enter the keywords port-channel then a

number. The range is from 1 to 128.

• For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port/subport information.

• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the

slot/port information.

•

For a VLAN, enter the keyword vlan then a number from 1 to 4094.

priority (OPTIONAL) Enter the priority used in Bootstrap election process. The range is

zero (0) to 255. The default is 192.

Defaults Not congured.

Command Modes CONFIGURATION

Command History

This guide is platform-specic. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.7(0.0) Added support for VRF. Introduced on the S6000-ON.

9.5(0.1) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

8.1.1.0 Introduced on the E-Series ExaScale.

7.8.1.0 Introduced on the S-Series.

pre- 6.1.1.1 Introduced on the E-Series.

Usage Information Priority is stored at BSR router when receiving a Candidate-RP-Advertisement.

ip pim sparse-mode

Enable PIM sparse mode and IGMP on the interface.

Syntax

ip pim sparse-mode

To disable PIM sparse mode and IGMP, use the no ip pim sparse-mode command.

Defaults Disabled.

Command Modes INTERFACE