Service Manual

Version Description
8.3.7.0 Introduced on the S4810.
Usage Information
NOTE: Per Port rate police is supported for Layer 2 tagged and untagged switched trac and for
Layer 3 trac. Per VLAN rate police is supported on only tagged ports with Layer 2 switched
trac.
S-Series
On one interface, you can congure the rate police command for a VLAN or you can congure the
rate police command for an interface. For each physical interface, you can congure three rate
police
commands specifying dierent VLANS.
rate shape
Shape the trac output on the selected interface.
S6000–ON
Syntax
rate shape [kbps] rate [burst-KB]
Parameters
kbps Enter the keyword kbps to specify the rate limit in Kilobits per second (Kbps). On
S-Series, make the value a multiple of 64. The range is from 0 to 40000000. The
default granularity is Megabits per second (Mbps).
rate The range is from 10 to 40000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is from 0 to 10000. The default
is 50.
Defaults Granularity for rate is Mbps unless you use the kbps option.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage Information
On 40-port 10G stack-unit if the trac is shaped between 64 and 1000 Kbs, for some values, the shaped
rate is much less than the value congured.
1076
Quality of Service (QoS)