Service Manual
NOTE: When packets of size greater than 7000 bytes are expected to be received from the
network, Dell Networking recommends that you congure the burst value to be more than 175 KB
if you congured the rate shape. Such a setting ensures proper bandwidth sharing across queues.
Related Commands rate-shape — shapes trac output as part of the designated policy.
service-class dynamic dot1p
Honor all 802.1p markings on incoming switched trac on an interface (from INTERFACE mode) or on all interfaces (from
CONFIGURATION mode). A CONFIGURATION mode entry supersedes an INTERFACE mode entry.
S6000–ON
Syntax
service-class dynamic dot1p
To return to the default setting, use the no service-class dynamic dot1p command.
Defaults All dot1p trac is mapped to Queue 0 unless you enable the service-class dynamic dot1p
command. The default mapping is as follows:
dot1p Queue ID
0 2
1 0
2 1
3 3
4 4
5 5
6 6
7 7
Command Modes
• INTERFACE
• CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Quality of Service (QoS)
1077