Service Manual

policy-map-output
Create an output policy map.
S6000–ON
Syntax
policy-map-output policy-map-name
To remove a policy map, use the no policy-map-output policy-map-name command.
Parameters
policy-map-name Enter the name for the policy map in character format (32 characters maximum).
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage Information To assign trac to dierent ows using QoS policy, use the Output Policy map. This command enables
Policy-Map-Output Conguration mode (conf-policy-map-out).
Related Commands
service-queue — assigns a class map and QoS policy to dierent queues.
policy-aggregate — allows an aggregate method of conguring per-port QoS using policy maps.
service-policy output — applies an output policy map to the selected interface.
qos-policy-input
Create a QoS input policy on the router.
S6000–ON
Syntax
qos-policy-input qos-policy-name cpu-qos | layer2
To remove an existing input QoS policy from the router, use the no qos-policy-input qos-policy-
name cpu-qos | layer2 command.
Parameters
qos-policy-name Enter the name for the policy map in character format (32 characters maximum).
cpu-qos (OPTIONAL) Enter the keyword cpu-qos keyword to assign this ACL to control
plane trac only.
Quality of Service (QoS)
1089