Service Manual
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Introduced on the S-Series and Z9000.
Usage Information
Use this command to bind an SNMP agent to a VRF. The SNMP agent processes the requests from the
interfaces that belong to the specied VRF. If no VRF is specied, then the default VRF is used.
Related Commands show snmp user — displays the information congured on each SNMP user name.
snmp trap link-status
Enable the interface to send SNMP link traps, which indicate whether the interface is up or down.
Syntax
snmp trap link-status
To disable sending link trap messages, use the no snmp trap link-status command.
Defaults Enabled.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information If the interface is expected to ap during normal usage, you could disable this command.
Syslog Commands
The following commands allow you to congure logging functions on all Dell Networking switches.
1290
Simple Network Management Protocol (SNMP) and Syslog