Service Manual

ip http vrf
Congures an HTTP client with a VRF that is used to connect to the HTTP server.
S6000–ON
Syntax
ip http vrf {management | vrf-name}
To undo the HTTP client conguration, use the ip http vrf command.
Parameters
management Enter the keyword management for conguring the management VRF that uses
an HTTP client.
vrf-name Enter the name of the VRF for conguring a nondefault that uses an HTTP client.
Defaults Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–ON, and Z9500.
Usage Information To make the HTTP clients VRF-aware, use the ip http vrf command. The HTTP client uses the VRF
name that you specify to reach the HTTP server. If you do not specify a VRF name, then the HTTP client
uses the default VRF.
ip route-export
Enables route leaking between VRFs. Exports or shares IPv4 routes corresponding to one VRF with other non-default VRFs.
Syntax
ip route-export tag [route-map-name]
Parameters
route-export Enter the keyword to leak or share routes between VRFs.
tag Enter a tag (export route target) to expose routes to other VRFs. This tag acts as
an identier for exported routes. You can use this identier while importing these
routes into another non-default VRF.
route-map-name (Optional) Enter the name of the route-map to lter the exported routes.
You can leak global routes to be made available to VRFs. As the global RTM usually
contains a large pool of routes, when the destination VRF imports global routes,
these routes will be duplicated into the VRF's RTM. As a result, it is mandatory to
use route-maps to lter out leaked routes while sharing global routes with VRFs.
Defaults N/A
Command Modes VRF MODE
1374
Virtual Routing and Forwarding (VRF)