Service Manual

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S6000 ON

1391

peer-routing

Enable L3 VLT peer-routing. This command is applicable for both IPV6/ IPV4.

Syntax

peer-routing

To disable L3 VLT peer-routing, use the no peer-routing command.

Defaults Disabled.

Command Modes VLT DOMAIN (conf-vlt-domain)

Command History

This guide is platform-specic. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.7(0.0) Introduced on the S6000-ON.

9.5(0.1) Introduced on the Z9500.

9.4(0.0) Added the support for IPV6 / IPV4.

9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-

Mux (PMUX) mode only.

9.2(0.2) Introduced on the Z9000, S4810, and S4820T.

peer-routing-timeout

Congure the delay after which peer routing is disabled when the peer is unavailable. This command is applicable for both IPV6/

IPV4. If not congured, peer-routing will not be disabled at all even though the peer is unavailable.

Syntax

peer-routing-timeout value

To restore the default value, use the no peer-routing-timeout command.

Parameters

value Enter the timeout value in seconds. The range is from 1 to 65535. The default value

is innity.