Service Manual

priority-cost (OPTIONAL) Enter a number as the amount to be subtracted from the priority
value. The range is 1 to 254. The default is 10.
Defaults priority cost = 10
Command Modes VRRP
Command History
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
7.6.1.0 Introduced on the S-Series (S50 only).
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information If the interface is disabled, the cost value is subtracted from the priority value and forces a new MASTER
election if the priority value is lower than the priority value in the BACKUP virtual routers.
virtual-address
Congure up to 12 IP addresses of virtual routers in the VRRP group. To start sending VRRP packets, set at least one virtual address
for the VRRP group.
Syntax
virtual-address ip-address1 [... ip-address12]
To delete one or more virtual IP addresses, use the no virtual-address ip-address1 [... ip-
address12] command.
Parameters
ip-address1 Enter an IP address of the virtual router in dotted decimal format. The IP address
must be on the same subnet as the interface’s primary IP address.
... ip-address12 (OPTIONAL) Enter up to 11 additional IP addresses of virtual routers in dotted
decimal format. Separate the IP addresses with a space. The IP addresses must be
on the same subnet as the interface’s primary IP address.
Defaults Not congured.
Command Modes VRRP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
1428
Virtual Router Redundancy Protocol (VRRP)