Service Manual

Example
An ACL rule with a TCP port lt 1023 uses only one entry in the CAM.
Rule# Data Mask From To #Covered
1 0000000000000000 1111110000000000 0 1023 1024
Total Ports: 1024
Related Commands
ip access-list extended — creates an extended ACL.
permit — assigns a permit lter for IP packets.
permit tcp — assigns a permit lter for TCP packets.
resequence access-list
Re-assign sequence numbers to entries of an existing access-list.
Syntax
resequence access-list {ipv4 | mac} {access-list-name StartingSeqNum Step-
to-Increment}
Parameters
ipv4 | mac Enter the keyword ipv4or mac to identify the access list type to resequence.
access-list-name Enter the name of a congured IP access list, up to 140 characters.
StartingSeqNum Enter the starting sequence number to resequence. The range is from 0 to
4294967290.
Step-to-Increment Enter the step to increment the sequence number. The range is from 1 to
4294967290.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale (IPv4).
7.8.1.0 Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names
were up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
192
Access Control Lists (ACL)