Service Manual

Version Description
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information Prex lists redistribute OSPF and RIP routes meeting specic criteria.
Related Commands
show ip route list — displays IP routes in an IP prex list.
show ip prex-list summary — displays a summary of the congured prex lists.
seq
To a deny or permit lter in a prex list while conguring the lter, assign a sequence number.
Syntax
seq sequence-number {deny | permit} {any} | [ip-prefix /nn {ge min-prefix-
length} {le max-prefix-length}] | [bitmask number]
To delete a specic lter, use the no seq sequence-number {deny | permit} {any} | [ip-
prefix {ge min-prefix-length} {le max-prefix-length}] | [bitmask number].
Parameters
sequence-number Enter a number. The range is from 1 to 4294967294.
deny Enter the keyword deny to congure a lter to drop packets meeting this
condition..
permit Enter the keyword permit to congure a lter to forward packets meeting this
condition.
any (OPTIONAL) Enter the keyword any to match any packets.
ip-prex /nn (OPTIONAL) Specify an IP prex in the network/length format. For example,
35.0.0.0/8 means match the rst 8 bits of address 35.0.0.0.
ge min-prex-
length
(OPTIONAL) Enter the keyword ge and then enter the minimum prex length,
which is a number from zero (0) to 32.
le max-prex-length (OPTIONAL) Enter the keyword le and then enter the maximum prex length,
which is a number from zero (0) to 32.
bitmask number Enter the keyword bitmask then enter a bit mask number in dotted decimal
format.
Defaults Not congured.
Command Modes PREFIX-LIST
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
212
Access Control Lists (ACL)