Service Manual

Usage Information
When you enter the reload command and the system reboots, you will not be prompted for a password to
enter the EXEC Privilege mode (normally you are required to enter the enable command).
If your console or Telnet session expires after you used the ignore enable-password command, you are
prompted for an enable password when you re-establish the session
Related Commands reload — Exit from this mode and reload FTOS.
ignore startup-cong
During a reload, do not load the startup-cong le.
Syntax ignore startup-cong
Defaults disabled
Command Modes BOOT_USER
Command History
Version 9.0.2.0 Introduced on the S6000.
Usage Information
Use this command if you have authentication procedures in the startup-cong other than the enable-
password setting.
interface management ethernet ip address
Assign an IP address to the Management Ethernet interface.
Syntax
[no] interface management ethernet ip address ip-address mask
To delete the IP address, enter no interface management ethernet ip address.
Defaults Not congured.
Command Modes BOOT_USER
Command History
Version 9.0.2.0 Introduced on the S6000.
Usage Information
In the runtime CLI, use the ip address command in INTERFACE mode to change the Management
interface’s IP address.
To view the current IP address congured on the Management interface, enter the show interfaces
management ethernet command
Related Commands show_default-gateway — Display the IP address congured for the default gateway.
286
Boot Command Line Interface