Service Manual

ipv6 Enter the ipv6 IP address to view the IPV6 route information.
keepalives Enter the keyword keepalives to view BGP keepalives.
notications Enter the keyword notifications to view BGP notications.
soft-reconguration Enter the keywords soft-reconfiguration to view only information on
inbound BGP soft reconguration.
updates Enter the keyword updates to view BGP updates.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
To view information on both incoming and outgoing routes, do not include the in and out parameters in the
debugging command. The in and out parameters cancel each other; for example, if you enter the debug
ip bgp in
command and then enter the debug ip bgp out command, you do not see information on
the incoming routes.
Entering a no debug ip bgp command removes all congured debug commands for BGP.
Related Commands
debug ip bgp events — views information about BGP events.
debug ip bgp keepalives — views information about BGP keepalives.
debug ip bgp notications — views information about BGP notications.
debug ip bgp updates — views information about BGP updates.
show debugging — views enabled debugging operations.
debug ip bgp dampening
View information on routes being dampened.
Syntax
debug ip bgp [vrf vrf-name] [ipv4 {unicast | multicast} | ipv6 unicast]
dampening
To disable debugging, use the no debug ip bgp dampening command.
Border Gateway Protocol
319