Service Manual

deny bandwidth
Enables you to specify link band width extended-community attribute as the matching criteria to deny incoming or outgoing trac.
Syntax
deny bandwidth
To disable this setting, enter the no deny bandwidth command.
Parameters
bandwidth Enter the keyword bandwidth to specify extended-community attribute as the
matching criteria for denying trac. The range is from 0 to 102400.
Defaults N/A
Command Modes EXTENDED COMMUNITY LIST
Command History
Version Description
9.7(0.0) Introduced on the S-Series.
Related Commands permit bandwidth – specify link band width extended-community attribute as the matching criteria to
permitting incoming or outgoing trac..
description
Enter a description of the BGP routing protocol
Syntax
description {description}
To remove the description, use the no description {description} command.
Parameters
description Enter a description to identify the BGP protocol (80 characters maximum).
Defaults none
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
326
Border Gateway Protocol