Service Manual

neighbor allowas-in
Set the number of times an AS number can occur in the AS path.
Syntax
neighbor {ip-address | peer-group-name} allowas-in number
To return to the default value, use the no neighbor {ip-address | peer-group-name}
allowas-in command.
Parameters
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to set the advertisement interval for all routers in
the peer group.
number Enter a number of times to allow this neighbor ID to use the AS path. The range is
from 1 to 10.
Defaults Not congured.
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
You cannot set this conguration for a peer that is associated with a peer group. Similarly, you cannot
associate a peer to a peer group if that peer is already congured with these settings.
Related Commands bgp four-octet-as-support — enables 4-byte support for the BGP process.
neighbor default-originate
Inject the default route to a BGP peer or neighbor.
Syntax
neighbor {ip-address | peer-group-name} default-originate [route-map map-
name]
To remove a default route, use the no neighbor {ip-address | peer-group-name} default-
originate command.
Border Gateway Protocol
331