Service Manual

Version Description
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series. Added 4-byte support.
Usage Information
Applies to EBGP neighbors only.
Congure your system to accept 4-byte formats before entering a 4 byte AS Number.
If the AS-PATH contains both public and private AS number or contains AS numbers of an EBGP neighbor,
the private AS numbers are not removed.
If a confederation contains private AS numbers in its AS-PATH, the software removes the private AS
numbers only if they follow the confederation numbers in the AS path.
Private AS numbers are from 64512 to 65535 (2 byte).
neighbor route-map
Apply an established route map to either incoming or outbound routes of a BGP neighbor or peer group.
Syntax
neighbor {ip-address | peer-group-name} route-map map-name {in | out}
To remove the route map, use the no neighbor {ip-address | peer-group-name} route-
map map-name {in | out} command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group.
map-name
Enter the name of an established route map.
If the Route map is not congured, the default is deny (to drop all routes).
in Enter the keyword in to lter inbound routes.
out Enter the keyword out to lter outbound routes.
NOTE: This command sends routes to peers only if an outbound policy is
congured and if there is a change in the existing outbound policy.
Defaults Not congured.
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
344
Border Gateway Protocol