Service Manual

Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf and then the name of the VRF to view ipv4–
unicast route information corresponding to that VRF.
ipv4 unicast (OPTIONAL) Enter the keywords ipv4 unicast to view information only related
to ipv4 unicast routes.
network (OPTIONAL) Enter the network address (in dotted decimal format) of the BGP
network to view information only on that network.
network-mask (OPTIONAL) Enter the network mask (in slash prex format) of the BGP network
address.
longer-prexes (OPTIONAL) Enter the keywords longer-prefixes to view all routes with a
common prex.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.4.(0.0) Added support for VRF.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Added the add-path option to the S4810. Output on the S4810 shows the
ADDPATH parameters.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information When you enable the bgp non-deterministic-med command, the show ip bgp command output
for a BGP route does not list the INACTIVE reason.
In BGP, this command displays the exact reason why the route is discarded.
The following describes the show ip bgp command shown in the following example.
Field Description
Network Displays the destination network prex of each BGP route.
Next Hop Displays the next hop address of the BGP router. If 0.0.0.0 is listed in this column,
then local routes exist in the routing table.
Metric Displays the BGP route’s metric, if assigned.
LocPrf Displays the BGP LOCAL_PREF attribute for the route.
360
Border Gateway Protocol