Service Manual

Ipv4Acl : 4
Ipv6Acl : 4
Ipv4Qos : 2
L2Qos : 1
L2PT : 0
IpMacAcl : 0
VmanQos : 0
EcfmAcl : 0
FcoeAcl : 0
iscsiOptAcl : 0
ipv4pbr : 0
vrfv4Acl : 0
Openflow : 0
fedgovacl : 0
nlbclusteracl: 0
test cam-usage
Verify that enough CAM space is available for the IPv6 ACLs you have created.
Syntax
test cam-usage service-policy input input policy name stack-unit {number | all}
Parameters
policy-map name Enter the name of the policy-map to verify. Maximum is 32 characters.
number Enter all to get information for all the linecards/stack-units or enter the linecard/ stack-unit
number to get information for a specic card. The range is 0-7 for all other S-Series. The range is
1-6.
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell Networking OS
Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced.
Usage Information
This command applies to both IPv4 and IPv6 CAM Proles, but is best used when verifying QoS optimization for IPv6 ACLs.
QoS Optimization for IPv6 ACLs does not impact the CAM usage for applying a policy on a single (or the rst of several)
interfaces. It is most useful when a policy is applied across multiple interfaces; it can reduce the impact to CAM usage across
subsequent interfaces.
The following describes the test cam-usage command shown in the following example.
Content Addressable Memory (CAM)
401