Service Manual

pfc no-drop queues
Congure the port queues that still function as no-drop queues for lossless trac.
Syntax
pfc no-drop queues queue-range
To remove the no-drop port queues, use the no pfc no-drop queues command.
Parameters
queue-range Enter the queue range. Separate the queue values with a comma; specify a priority
range with a dash; for example, pfc no-drop queues 1,3 or pfc no-drop
queues 7 or pfc no-drop queues 0,7. The range is from 0 to 3.
Defaults No lossless queues are congured.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
• When you congure lossless queues on an interface, PFC priority conguration is not allowed on the
dcb-input prole applied on the interface.
• The maximum number of lossless queues globally supported on the switch is two.
The following lists the dot1p priority-queue assignments.
dot1p Value in
the Incoming
Frame
Description heading
0 0
1 0
2 0
3 1
4 2
5 3
6 3
7 3
Data Center Bridging (DCB)
413