Service Manual

Command History

This guide is platform-specic. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

Version

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.12.0 Introduced on the S4810.

8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

By default, iSCSI is enabled on the unit and the ow control is enabled on all of the interfaces. It is also acts

as defaults when the link-level ow control is enabled on one or more interfaces.

Enables priority ow control or enhance transmission selection on interface.

Related Commands dcb <ets | pfc> enable — enable priority ow control or enhanced transmission selection on interface.

clear ets counters

Clear all ETS TLV counters on an interface.

Syntax

clear ets counters port-type slot/port[/subport]

Parameters

port-type Enter the keywords port-type then the slot/port information. Enter the subport

number if a 40G port is fanned-out into 10G ports.

Defaults none

Command Modes EXEC Privilege