Service Manual

no shutdown
Dell(conf-if-fo-1/4)#
show cong (for speed)
Syntax
show config
Command Modes INTERFACE MODE
Command History
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.3(0.1) Introduced on the S6000.
Usage Information
In order for the speed information corresponding to an interface to appear in the show command output,
you must rst congure the speed of that interface using the speed command.
Example
Dell(conf-if-te-1/1/1)#speed ?
100 100 Mbps
1000 1000 Mbps
10000 10000 Mbps
auto Auto negotiation (default)
Dell(conf-if-te-1/1/1)#speed 100
Dell(conf-if-te-1/1/1)#show config
interface TenGigabitEthernet 1/1/1
speed 100
no shutdown
show cong (from INTERFACE RANGE mode)
Display the bulk congured interfaces (interface range).
Syntax
show config
Command Modes CONFIGURATION INTERFACE (conf-if-range)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Interfaces
603