Service Manual

Dell(conf)#00:02:24: %STKUNIT1-M:CP %IFMGR-5-DYNAMIC_FANOUT: Port 24 in
slot 1 has been fanned-out >>>>>
Dell(conf)#00:02:27: %S6000-ON:1 %IFAGT-5-INSERT_OPTICS_QSFP: Optics QSFP
inserted in slot 1 port 24/2
00:02:27: %S6000-ON:1 %IFAGT-5-INSERT_OPTICS_QSFP: Optics QSFP inserted in
slot 1 port 24/3
i00:02:27: %S6000-ON:1 %IFAGT-5-INSERT_OPTICS_QSFP: Optics QSFP inserted
in slot 1 port 24/4
Related Commands stack-unit portmode — splits a single 40G port into four-10G ports
stack-unit quad-port-prole
Congures the list of dynamic fan-out capable ports.
Syntax
stack-unit [stack-unit number] quad-port-profile [default|<1–32>]
To remove the quad-port conguration, use the [no] stack-unit[stack-unit number] quad-
port-profile [default|<1–32>]command syntax.
Parameters
stack-unit
number<1–32>
Enter the port number. The range is from 1 to 6.
The range of the default ports are separated by —,
Defaults 2,4,6,8,9,10,11,12,13,14,15,16,17,18,19,20,21,22,23,24,25,27,29,31
Command Modes CONFIGURATION
Command History
Version Description
9.7(0.0) Introduced on the S6000 and S6000–ON.
Usage Information
The prole can only have 12-port groups in the rst 16 and last 16 groups. Any change in the prole needs
save and reload.
show interfaces switchport
Display only virtual and physical interfaces in Layer 2 mode. This command displays the Layer 2 mode interfaces’ IEEE 802.1Q tag
status and VLAN membership.
Syntax
show interfaces switchport [interface | stack-unit unit-id ]
Parameters
interface (OPTIONAL) Enter one of the following keywords and slot/port[/subport] or
number information:
• For a port channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
• For a backup interface for this interface, enter the keyword backup.
616
Interfaces