Service Manual

Vlan membership:
Vlan 2
--More--
Related Commands
interface — congures a physical interface on the switch.
show ip interface — displays Layer 3 information about the interfaces.
show interfaces — displays information on a specic physical interface or virtual interface.
show interfaces transceiver — displays the physical status and operational status of an installed transceiver.
The output also displays the transceiver’s serial number.
show interfaces transceiver
Display the physical status and operational status of an installed transceiver. The output also displays the transceiver’s serial number.
Syntax
show interfaces [tengigabitethernet slot/port[/subport] | fortyGigE slot/
port] transceiver
Parameters
tengigabitethernet For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port/subport information.
fortyGigE For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on theS6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Output augmented with diagnostic data for pluggable media.
7.7.1.0 Removed three elds in the output: Vendor Name, Vendor OUI, and Vendor PN.
7.6.1.0 Introduced on the C-Series and S-Series.
6.5.4.0 Introduced on the E-Series.
618
Interfaces