Service Manual

The following is a list of the Dell Networking OS version history for this command.
Version Description
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
Usage Information
Because this command calculates based on a Layer 2 hash algorithm, use this command to display ows for
switched Layer 2 packets, not for routed packets (use the show ip flow command to display routed
packets).
The show port-channel-flow command returns the egress port identication in a given port-channel
if a valid ow is entered. A mismatched ow error occurs if MAC-based hashing is congured for a Layer 2
interface and you are trying to display a Layer 3 ow.
The output displays three entries:
• Egress port for unfragmented packets.
• In the event of fragmented packets, the egress port of the rst fragment.
• In the event of fragmented packets, the egress port of the subsequent fragments.
NOTE: In the show port channel flow command output, the egress port for an unknown
unicast, multicast, or broadcast trac is not displayed.
The following example shows the show port-channel-flow outgoing-port-channel number
incoming-interface interface source-mac address destination-mac address
• Load-balance is congured for MAC
• Load-balance is congured for IP 4-tuple/2-tuple
• A non-IP payload is going out of Layer 2 LAG interface that is a member of VLAN with an IP address
Example
Enhanced Validation of Interface Ranges
This functionality is supported on the platform.
You can avoid specifying spaces between the range of interfaces, separated by commas, that you congure by using the
interface range command. For example, if you enter a list of interface ranges, such as interface range fo 1/1-1,te
2/1/1, this conguration is considered valid. The comma-separated list is not required to be separated by spaces in between the
ranges. You can associate multicast MAC or hardware addresses to an interface range and VLANs by using the
mac-address-
table static multicast-mac-address vlan vlan-id output-range interface command.
ip http source-interface
Specify an interface as the source interface for HTTP connections.
This feature is supported on platform.
Interfaces
637