Service Manual

Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Related Commands show ip interface — displays the interface routing status and conguration.
ip route
Assign a static route to the switch.
Syntax
ip route [vrf vrf-name] ip-address mask {ip-address | interface [ip-
address]} [distance] [permanent] [tag tag-value] [vrf vrf-name] [weight
weight-value]
To delete a specic static route, use the no ip route destination mask command.
To delete all routes matching a certain route, use the no ip route destination mask command.
Parameters
destination Enter the IP address in dotted decimal format of the destination device.
mask Enter the mask in the slash prex format (/x) of the destination IP address.
ip-address Enter the IP address of the forwarding router in dotted decimal format.
interface Enter one of the following keyword followed by the slot/port[/subport] number:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
•
For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
• For the Management interface on the stack-unit, enter the keyword
ManagementEthernet then the slot/port information. The slot range is from
1 to 6. The port range is 1.
• For a port channel interface, enter the keywords port-channel then a
number.
• For a Null interface, enter the keyword null then the Null interface number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
666
IPv4 Routing