Service Manual

Example (Brief)
Dell#show ip interface brief
Interface IP-Address OK? Method Status
Protocol
TenGigabitEthernet 1/1/1 unassigned NO Manual administratively down
down
TenGigabitEthernet 1/1/2 unassigned NO Manual administratively down
down
TenGigabitEthernet 1/1/3 unassigned YES Manual up up
TenGigabitEthernet 1/1/4 unassigned YES Manual up up
TenGigabitEthernet 1/2/1 unassigned YES Manual up up
TenGigabitEthernet 1/2/2 10.10.10.1 YES Manual up up
TenGigabitEthernet 1/2/3 unassigned NO Manual administratively down
down
show ip management-route
View the IP addresses assigned to the Management interface.
Syntax
show ip management-route [all | connected | summary | static]
Parameters
all (OPTIONAL) Enter the keyword all to view all IP addresses assigned to all
Management interfaces on the switch.
connected (OPTIONAL) Enter the keyword connected to view only routes directly
connected to the Management interface.
summary (OPTIONAL) Enter the keyword summary to view a table listing the number of
active and non-active routes and their sources.
static (OPTIONAL) Enter the keyword static to view non-active routes also.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.5.1.0 Introduced on the C-Series.
688
IPv4 Routing