Service Manual

mac learning-limit reset
Reset the MAC address learning-limit error-disabled state.
Syntax
mac learning-limit reset
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.5.1.0 Introduced on the E-Series.
show mac-address-table
Display the MAC address table.
Syntax
show mac-address-table [address mac-address | interface interface | vlan
vlan-id] [aging-time] [dynamic | static] [count [vlan vlan-id] [interface
interface-type [slot [/port[/subport]]]]]
Parameters
address mac-
address
(OPTIONAL) Enter the keyword address then a MAC address in the
nn:nn:nn:nn:nn:nn format to display information on that MAC address.
dynamic (OPTIONAL) Enter the keyword dynamic to display only those MAC addresses
the switch dynamically learns. Optionally, you can also add one of these
combinations: address/mac-address, interface/interface, or vlan
vlan-id.
static (OPTIONAL) Enter the keyword static to display only those MAC addresses
specically congured on the switch. Optionally, you can also add one of these
combinations: address/mac-address, interface/interface, or vlan
vlan-id.
Layer 2
795