Service Manual

• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
count value Enter the keyword count then the number of debug outputs. The range is from 1
to 65534. The default is innity.
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, and Z9000 switches.
device-role
Specify the role of the device attached to the port.
Syntax
device-role {host | router}
To reset the device role, use the no device-role {host | router} command.
Parameters
host Enter the keyword host to set the device-role as host.
router Enter the keyword router to set the device-role as router.
Defaults none
Command Modes POLICY LIST CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, and Z9000 switches.
Related Commands
• ipv6 nd raguard policy policy-name — Denes the RA guard policy name and enter the RA guard policy
conguration mode.
• ipv6 nd ra-guard enable — Allows you to congure the RA guard related commands.
880
Neighbor Discovery Protocol (NDP)