Service Manual

ipv6 neighbor
Congure a static entry in the IPv6 neighbor discovery.
Syntax
ipv6 neighbor {ipv6-address} {interface interface} {hardware_address}
To remove a static IPv6 entry from the IPv6 neighbor discovery, use the no ipv6 neighbor {ipv6-
address} {interface interface} command.
Parameters
ipv6-address Enter the IPv6 address of the neighbor in the x:x:x:x::x format.
NOTE: The :: notation species successive hexadecimal elds of zero.
interface interface Enter the keyword interface then the interface type and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport information.
•
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
• For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
• For a port channel interface, enter the keywords port-channel then a
number.
• For a Null interface, enter the keyword null then the Null interface number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• For a tunnel interface, enter the keyword tunnel then the tunnel interface
number. The range is from 1 to 16383.
hardware_address Enter a 48-bit hardware MAC address in nn:nn:nn:nn:nn:nn format.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
Neighbor Discovery Protocol (NDP)
883