Service Manual

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S6000 ON

881

882

883

884

885

886

887

888

889

890

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.7(0.0) Introduced on the S6000-ON.

9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, and Z9000 switches.

Related Commands

• ipv6 nd ra-guard enable — Allows you to congure the RA guard related commands.

• ipv6 nd raguard policy policy-name — Denes the RA guard policy name and enter the RA guard policy

conguration mode.

match ra

Enable verifying either of the congured source IPv6 address or prex address or the source MAC address in the inspected

messages. If this command is not congured, the verication process is bypassed.

Syntax

match ra {ipv6-access-list name | ipv6-prefix-list name | mac-access-list

name}

To reset the access list, use the no match ra{ipv6-access-list | ipv6-prefix-list |

mac-access-list}command.

Parameters

ipv6–access-list

name

Enter the keywords ipv6–access-list then the access-list name. The access-

list name allows a maximum of 140 characters.

ipv6–prex-list

name

Enter the keywords ipv6–prefix-list then the prex-list name. The prex-list

name allows a maximum of 140 characters.

ipv6–mac-access-

list name

Enter the keywords ipv6–mac-access-list then the mac-access-list name.

The mac-access-list name allows a maximum of 140 characters.

Defaults none

Command Modes POLICY LIST CONFIGURATION

Command History

This guide is platform-specic. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.