Service Manual

Version Description
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
mib-binding
Enable this OSPF process ID to manage the SNMP traps and process SNMP queries.
S6000–ON
Syntax
mib-binding
To mib-binding on this OSPF process, use the no mib-binding command.
Defaults none.
Command Modes ROUTER OSPF
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced to all platforms.
Usage Information
This command is either enabled or disabled. If no OSPF process is identied as the MIB manager, the rst
OSPF process is used.
If an OSPF process has been selected, it must be disabled prior to assigning new process ID the MIB
responsibility.
network area
Dene which interfaces run OSPF and the OSPF area for those interfaces.
S6000–ON
Syntax
network ip-address mask area area-id
To disable an OSPF area, use the no network ip-address mask area area-id command.
Parameters
ip-address Specify a primary or secondary address in dotted decimal format. The primary
address is required before adding the secondary address.
Open Shortest Path First (OSPFv2 and OSPFv3)
939