Users Guide

these mappings are identical. This section discusses the Dell Networking OS configurations needed for above PFC generation
and honoring mechanism to work for the untagged packets.
PRIORITY to PG mapping (PRIO2PG) is on the ingress for each port. By default, all priorities are mapped to PG7. A priority for
which PFC has to be generated is assigned to a PG other than PG7 (say PG6) and buffer watermark is set on PG6 so as to
generate PFC.
In ingress, the buffers are accounted at per PG basis and would indicate the number of the packets that has ingress this port PG
but still queued up in egress pipeline. However, there is no direct mapping between the PG and Queue.
Packet is assigned an internal priority on the ingress pipeline based on the queue to which it is destined. This Internal-priority to
Queue mapping has been modified and enhanced as follows for the device:
Table 18. Priority to Queue Mapping
Internal-
priority
0 1 2 3 4 5 6 7
Queue
2 0 1 3 4 5 6 7
Default dot1p to queue configuration is as follows:
Table 19. Dot1p to Queue Mapping
Packet-
Dot1p
0 1 2 3 4 5 6 7
Queue
2 0 1 3 4 5 6 7
PFC and ETS Configuration Examples
This section contains examples of how to configure and apply DCB policies on an interface.
Using PFC to Manage Converged Ethernet Traffic
To use PFC for managing converged Ethernet traffic, use the following command:
dcb-map stack-unit all dcb-map-name
Operations on Untagged Packets
The below is example for enabling PFC for priority 2 for tagged packets. Priority (Packet Dot1p) 2 will be mapped to PG6 on
PRIO2PG setting. All other Priorities for which PFC is not enabled are mapped to default PG – PG7.
Classification rules on ingress (Ingress FP CAM region) matches incoming packet-dot1p and assigns an internal priority (to
select queue as per Table 1 and Table 2).
The internal Priority assigned for the packet by Ingress FP is used by the memory management unit (MMU) to assign the packet
to right queue by indexing the internal-priority to queue map table (TABLE 1) in hardware.
PRIO2COS setting for honoring the PFC protocol packets from the Peer switches is as per above Packet-Dot1p->queue table
(Table 2).
The packets that come in with packet-dot1p 2 alone will be assigned to PG6 on ingress.
Data Center Bridging (DCB) 237