Users Guide

Dynamically assigned IP addresses can be released without removing the DHCP client operation on the interface on a
switch configured as a DHCP client.
3 Manually acquire a new IP address from the DHCP server by releasing a dynamically acquired IP address while retaining the
DHCP client configuration on the interface.
EXEC Privilege mode
release dhcp interface type slot/port[/subport]
4 Acquire a new IP address with renewed lease time from a DHCP server.
EXEC Privilege mode
renew dhcp interface type slot/port[/subport]
To display DHCP client information, use the following show commands in EXEC Privilege mode.
• To display statistics about DHCP client interfaces, use the show ip dhcp client statistics interface type
slot/port
[subport] command.
• To clear DHCP client statistics on a specified or on all interfaces, use the clear ip dhcp client statistics {all |
interface type slot/port[/subport]} command.
• To display dynamic IP address lease information currently assigned to a DHCP client interface, use the show ip dhcp
lease [interface type slot/port[/subport]] command.
• To display log messages for all DHCP packets sent and received on DHCP client interfaces, use the debug ip dhcp
client packets [interface
type slot/port[/subport] command.
• To display log message on DHCP client interfaces for IP address acquisition, IP address release, IP address and lease time
renewal, and release an IP address, use the [no] debug ip dhcp client events [interface type slot/port[/
subport
]] command.
DHCP Client on a Management Interface
These conditions apply when you enable a management interface to operate as a DHCP client.
• The management default route is added with the gateway as the router IP address received in the DHCP ACK packet. It is
required to send and receive traffic to and from other subnets on the external network. The route is added irrespective
when the DHCP client and server are in the same or different subnets. The management default route is deleted if the
management IP address is released like other DHCP client management routes.
• ip route for 0.0.0.0 takes precedence if it is present or added later.
• Management routes added by a DHCP client display with Route Source as DHCP in the show ip management route and
show ip management-route dynamic command output.
• Management routes added by DHCP are automatically reinstalled if you configure a static IP route with the ip route
command that replaces a management route added by the DHCP client. If you remove the statically configured IP route
using the no ip route command, the management route is reinstalled. Manually delete management routes added by the
DHCP client.
• To reinstall management routes added by the DHCP client that is removed or replaced by the same statically configured
management routes, release the DHCP IP address and renew it on the management interface.
• Management routes added by the DHCP client have higher precedence over the same statically configured management
route. Static routes are not removed from the running configuration if a dynamically acquired management route added by
the DHCP client overwrites a static management route.
• Management routes added by the DHCP client are not added to the running configuration.
NOTE: Management routes added by the DHCP client include the specific routes to reach a DHCP server in a different
subnet and the management route.
Dynamic Host Configuration Protocol (DHCP) 272