Users Guide

In the following example, the host and server are exchanging traffic which passes through the uplink interface 1/1/1. Port 1/1/1
is the monitored port and port 1/32/1 is the destination port, which is configured to only monitor traffic received on
tengigabitethernet 1/1/1 (host-originated traffic).
Figure 96. Port Monitoring Example
Configuring Monitor Multicast Queue
To configure monitor QoS multicast queue ID, use the following commands.
1 Configure monitor QoS multicast queue ID.
CONFIGURATION mode
monitor multicast-queue queue-id
Dell(conf)#monitor multicast-queue 7
2 Verify information about monitor configurations.
EXEC mode
EXEC Privilege mode
show run monitor session
Dell#show run monitor session
!
monitor multicast-queue 7
Dell#
Port Monitoring 624