Users Guide

!
ip access-list standard dscp_40_non_ecn
seq 5 permit any dscp 40 ecn 0
!
class-map match-any class_dscp_40
match ip access-group dscp_40_non_ecn set-color yellow
match ip access-group dscp_40_ecn
!
class-map match-any class_dscp_50
match ip access-group dscp_50_non_ecn set-color yellow
match ip access-group dscp_50_ecn
!
policy-map-input pmap_dscp_40_50
service-queue 2 class-map class_dscp_40
service-queue 3 class-map class_dscp_50
Applying Layer 2 Match Criteria on a Layer 3
Interface
To process Layer 3 packets that contain a dot1p (IEEE 802.1p) VLAN Layer 2 header, configure VLAN tags on a Layer 3 port
interface which is configured with an IP address but has no VLAN associated with it. You can also configure a VLAN sub-
interface on the port interface and apply a policy map that classifies packets using the dot1p VLAN ID.
To apply an input policy map with Layer 2 match criteria to a Layer 3 port interface, use the service-policy input
policy-name layer 2
command in Interface configuration mode.
To apply a Layer 2 policy on a Layer 3 interface:
1 Configure an interface with an IP address or a VLAN sub-interface
CONFIGURATION mode
Dell(conf)# interface fo 1/4
INTERFACE mode
Dell(conf-if-fo-1/4)# ip address 90.1.1.1/16
2 Configure a Layer 2 QoS policy with Layer 2 (Dot1p or source MAC-based) match criteria.
CONFIGURATION mode
Dell(conf)# policy-map-input l2p layer2
3 Apply the Layer 2 policy on a Layer 3 interface.
INTERFACE mode
Dell(conf-if-fo-1/4)# service-policy input l2p layer2
Managing Hardware Buffer Statistics
The memory management unit (MMU) is 12.2 MB in size. It contains approximately 60,000 cells, each of which is 208 bytes in
size. MMU also has another portion of 3 MB allocated to it. The entire MMU space is shared across a maximum of 104 logical
ports to support the egress admission-control functionality to implement scheduling and shaping on per-port and per-queue
levels. Also, the MMU buffer cells can be used by each port or queue either as a static partition or as a dynamic partition. With
dynamic mode, you can specify the percentage of available buffer that is utilized by a queue. This dynamic partition or block is
set to be two-thirds of the available buffers for all unicast queues and one-fifth of the available buffers for all multicast queues
on these platforms.
The maximum number of ports, including fan-out, supported is 104 and the maximum number of queues supported is 21.
Analyzing and evaluating buffer statistics enables monitoring of resources and tuning of allocation of buffers. Max Use count
Quality of Service (QoS) 685