Administrator Guide

Table 14. UFT Modes — Table Size
UFT Mode L2 MAC Table Size L3 Host Table Size L3 LPM Table Size
Default 160K 144K 16K
Scaled-l3-hosts 96K 208K 16K
Scaled-l3-routes 32K 16K 128K
Configuring UFT Modes
To configure the Unified Forwarding Table (UFT) modes, follow these steps.
1. Select a mode to initialize the maximum scalability size for L2 MAC table or L3 Host table or L3 Route table.
CONFIGURATION
hardware forwarding-table mode
DellEMC(conf)#hardware forwarding-table mode ?
scaled-l3-hosts Forwarding table mode for scaling L3 host entries
scaled-l3-routes Forwarding table mode for scaling L3 route entries
DellEMC(conf)#
DellEMC(conf)#hardware forwarding-table mode scaled-l3-hosts
Hardware forwarding-table mode is changed. Save the configuration and reload to take
effect.
DellEMC(conf)#end
DellEMC#write mem
!
01:13:36: %STKUNIT0-M:CP %FILEMGR-5-FILESAVED: Copied running-config to startup-config in
flash by default
DellEMC(conf)#
DellEMC(conf)#end
DellEMC#01:13:44: %STKUNIT0-M:CP %SYS-5-CONFIG_I: Configured from console
DellEMC#
2. Display the hardware forwarding table mode in the current boot and in the next boot.
EXEC Privilege
show hardware forwarding-table mode
Content Addressable Memory (CAM)
219