Administrator Guide

(*, 192.1.2.1), uptime 00:29:36, expires 00:03:26, RP 10.87.2.6, flags: SCJ
Incoming interface: FortyGigE 1/12/1, RPF neighbor 10.87.3.5
Outgoing interface list:
FortyGigE 1/11/1
FortyGigE 1/13/1
(10.87.31.5, 192.1.2.1), uptime 00:01:24, expires 00:02:26, flags: FT
Incoming interface: FortyGigE 1/10/1, RPF neighbor 0.0.0.0
Outgoing interface list:
FortyGigE 1/11/1
FortyGigE 1/12/1
FortyGigE 1/13/1
--More--
Following is an example of show ipv6 pim tib command output:
DellEMC#show ipv6 pim tib
PIM Multicast Routing Table
Flags: D - Dense, S - Sparse, C - Connected, L - Local, P - Pruned,
R - RP-bit set, F - Register flag, T - SPT-bit set, J - Join SPT,
Timers: Uptime/Expires
Interface state: Interface, next-Hop, State/Mode
(*, ff0e::225:1:2:1), uptime 00:29:36, expires 00:03:26, RP 10.87.2.6, flags: SCJ
Incoming interface: FortyGigE 1/12/1, RPF neighbor 35::1
Outgoing interface list:
FortyGigE 1/11/1
FortyGigE 1/13/1
(25::1, ff0e::225:1:2:1), uptime 00:01:24, expires 00:02:26, flags: FT
Incoming interface: FortyGigE 1/10/1, RPF neighbor 35::1
Outgoing interface list:
FortyGigE 1/11/1
FortyGigE 1/12/1
FortyGigE 1/13/1
Configuring S,G Expiry Timers
You can configure a global expiry time (for all [S,G] entries). By default, [S,G] entries expire in 210 seconds.
When you create, delete, or update an expiry time, the changes are applied when the keep alive timer refreshes.
To configure a global expiry time, use the following command.
Enable global expiry timer for S, G entries.
CONFIGURATION mode
{ip | ipv6} pim sparse-mode sg-expiry-timer seconds
The range is from 211 to 86,400 seconds.
The default is 210.
NOTE:
The global expiry time for all [S, G] entries can vary from 360 to 420 seconds.
To display the expiry time configuration, use the show running-configuration pim command from EXEC Privilege mode.
DellEMC#show running-configuration pim
!
ipv6 pim sparse-mode
ipv6 pim dr-priority 10
ipv6 pim rp-address 52::40:4:4 group-address ff0e::/64
ipv6 pim sparse-mode sg-expiry-timer 211
DellEMC#
PIM Sparse-Mode (PIM-SM)
617