Users Guide

timers throttle lsa arrival
Configure the LSA acceptance intervals.
Syntax
timers throttle lsa arrival arrival-time
To return to the default, use the no timers throttle lsa command.
Parameters
arrival-time Set the interval between receiving the same LSA repeatedly, to allow sufficient time for
the system to accept the LSA. The range is from 0 to 600,000 milliseconds.
Defaults 1000 msec
Command Modes ROUTER OSPF
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Introduced on the S4810.
OSPFv3 Commands
Open shortest path first version 3 (OSPFv3) for IPv6 is supported on the platform.
The fundamental mechanisms of OSPF (flooding, DR election, area support, SPF calculations, and so on) remain unchanged. However,
OSPFv3 runs on a per-link basis instead of on a per-IP-subnet basis. Most changes were necessary to handle the increased address size of
IPv6.
The Dell Networking implementation of OSPFv3 is based on IETF RFC 2740.
1106
Open Shortest Path First (OSPFv2 and OSPFv3)