Users Guide

Defaults Disabled
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0) Introduced on the S4048–ON.
9.4(0.0) Introduced on the S6000.
Usage Information You must disable vxlan-instance before unconfiguring VAP.
Related Commands feature vxlan — Enable VXLAN configuration globally on the platform.
vxlan-instance static
Enable VXLAN instance configuration to be static on the platform.
Syntax
vxlan-instance instance ID [static]
To delete VXLAN instance from the system, use no vxlan-instance instance ID command.
Parameters
instance ID Enter the VXLAN instance ID. The platform supports only the instance ID 1 in the initial
release.
static Enter the keyword static to set the VXLAN instance in static mode.
Defaults Controller mode.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.11(0.0) Introduced on the S4048–ON, S4048T-ON, S6000–ON, S6010–ON, S6100–ON, and
Z9100–ON.
Usage Information
By default, VXLAN instance is created in controller mode. You need a controller to configure VTEP. When you
create VXLAN instance in static mode, you can configure VTEP through CLIs.
Use the no shutdown command to enable the VXLAN instance.
Only one VXLAN instance can exist in a system.
You cannot modify a VXLAN instance mode. If you need to change the mode, you can delete the existing VXLAN
instance and create a new instance with the required mode.
1648 Virtual Extensible LAN (VXLAN)