Users Guide

Usage Information
After enabling the range option, create the range profiles using the aclrange profile-name command.
Reboot the system for the range profiles to come up.
Related Commands aclrange profile-name — Create range profiles.
ip access-group
Assign an IP access list (IP ACL) to an interface.
Syntax
ip access-group access-list-name {in | out} [implicit-permit] [vlan vlan-id]
[vrf vrf-name]
To delete an IP access-group configuration, use the no ip access-group access-list-name {in |
out} [implicit-permit] [vlan vlan-id] [vrf vrf-name] command.
Parameters
access-list-name Enter the name of a configured access list, up to 140 characters.
in Enter the keyword in to apply the ACL to incoming traffic.
out Enter the keyword out to apply the ACL to outgoing traffic.
implicit-permit (OPTIONAL) Enter the keyword implicit-permit to change the default action of
the ACL from implicit-deny to implicit-permit (that is, if the traffic does not match the
filters in the ACL, the traffic is permitted instead of dropped).
vlan vlan-id (OPTIONAL) Enter the keyword vlan then the ID numbers of the VLANs. The range is
from 1 to 4094 (you can use IDs from 1 to 4094).
vrf vrf-name (OPTIONAL) Enter the keyword vrf then the ID numbers of the VRFs. The range is
from 1 to 63 (you can use IDs from 1 to 63).
NOTE: When you specify a single VRF, use the name of the VRF instead of
the VRF ID number. Use the VRF ID numbers only when you specify a range
of VRFs.
Defaults Not enabled.
Command Modes INTERFACE/VRF MODE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
Access Control Lists (ACL) 183