Users Guide

You can activate flow-based monitoring for a monitoring session by entering the flow-based enable command in
the Monitor Session mode. When you enable this capability, traffic with particular flows that are traversing
through the ingress and egress interfaces are examined and, appropriate ACLs can be applied in both the ingress
and egress direction. Flow-based monitoring conserves bandwidth by monitoring only specified traffic instead all
traffic on the interface. This feature is particularly useful when looking for malicious traffic. It is available for Layer
2 and Layer 3 ingress and egress traffic. You may specify traffic using standard or extended access-lists. This
mechanism copies all incoming or outgoing packets on one port and forwards (mirrors) them to another port. The
source port is the monitored port (MD) and the destination port is the monitoring port (MG).
deny icmp (for Extended IPv6 ACLs)
Configure a filter to drop all or specific ICMP messages.
NOTE: Only the options that have been newly introduced in Release 9.3(0.0) and Release 9.4(0.0) are described here. For a
complete description on all of the keywords and variables that are available with this command, refer the topic of this command
discussed earlier in this guide.
Syntax
deny icmp {source address mask | any | host ipv6-address} {destination address
| any | host ipv6-address} [message-type] [count [byte]] | [log [interval
minutes] [threshold-in-msgs [count]] [monitor]
To remove this filter, you have two choices:
• Use the no seq sequence-number command syntax if you know the filter’s sequence number
•
Use the no deny icmp {source address mask | any | host ipv6-address}
{destination address | any | host ipv6-address} command
Parameters
log (OPTIONAL) Enter the keyword log to enable the triggering of ACL log messages.
threshold-in msgs
count
(OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to indicate
the maximum number of ACL logs that can be generated, exceeding which the
generation of ACL logs is terminated. with the seq, permit, or deny commands. You can
enter a threshold in the range of 1-100.
interval minutes (OPTIONAL) Enter the keyword interval followed by the time period in minutes at
which ACL logs must be generated. You can enter an interval in the range of 1-10
minutes.
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic that
you want to monitor and the ACL in which you are creating the rule is applied to the
monitored interface.
Defaults
By default, 10 ACL logs are generated if you do not specify the threshold explicitly.
The default frequency at which ACL logs are generated is 5 minutes. By default, flow-based monitoring is not
enabled.
Command Modes ACCESS-LIST
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
300 Access Control Lists (ACL)